On eBay Kleinanzeigen I came across a Black&Decker Workmate. In need of repair and free to a good home. The pick-up location meant I did not have to make a big detour on the way back from Augsburg.
The seller was really nice. He had dismantled the little workbench and packed it into the original box of the Workmate he had bought as a replacement.
The wooden parts are in poor condition; one of the two cranks has broken off and was provisionally repaired by him. All the small parts are in a little bag in the box, so nothing can get lost or broken.
An ideal starting point not only for repairing the Workmate but also for improving it with my experience!
Repairing the hand crank
Replacing the hand crank is the smallest problem. I simply reprint the broken part on the 3D printer. There are plenty of ready-made models on the internet, but they are designed so that the handle of the crank is fixed with a screw. In some cases you also need to print the other part of the crank yourself so that everything fits together.
Since the second crank is still intact, it is no great problem to measure it and redraw it. The springs on the orange part that hold it in position are hard to measure, because I cannot get the two parts apart. Here I improvise a little and simplify the design.
I decide to print the handle horizontally because I hope this will make it stronger. I accept that I will need a lot of support material for that.
At 50% infill my Ender 5 needs about an hour and a half to grow the coveted part, including supports, on the print bed. I do have orange filament in stock but use the black that happens to be in the printer anyway. The manufacturer advertises its good mechanical properties, and since it is for me I am not that fussy.
After printing I remove the support structure and sand the places where it was attached to the part a little.
It only goes into the opening of the crank with difficulty, but then it engages with an audible ‘click’. I will probably be just as unable to get it out again as the original part.
It sits rather tightly in the lifting arm; the original has noticeable play here and turns far more easily. I probably mismeasured the length of the axle – or rather misjudged it, because since I could not get the original part out, I could more or less only estimate the length.
Never mind – I cannot get it out again to sand it down a little, and I do not want to print a new one unnecessarily. Upcycling is environmental protection in practice, so it does not always have to be 1000% perfect. My freshly printed part does turn, after all; perhaps I will help it along with a little silicone spray at some point 😉
to be continued …
