Which glue for which job: white PVA glue, water-resistant D4 glue, fish glue, contact and two-component adhesives, with tips on applying wood glue correctly.
Glues and adhesives are indispensable when something cannot be joined with screws and nails. Different adhesives are used depending on the material and surface. Drawing on my own experience, I try to describe which adhesive is best suited to which application.
Adhesives
Adhesives are versatile and are used especially where screws or nails are unsuitable. Applied correctly, they are almost invisible.
Everything important about adhesives at a glance
Handling glue and adhesive correctly is decisive for a lasting bond. Here are some important types of adhesive:
- Standard white (PVA) wood glue
- Fast-setting white glue
- Water-resistant glue
- Glue for lacquered surfaces
- Two-component adhesive
- Fish glue
- D4 glue
White glue is a water-based dispersion adhesive that can hardly be dissolved with water once it has dried. The water-resistant version is particularly suitable for outdoor use or damp environments.
Glue for lacquered surfaces holds on lacquered wood and plastic surfaces.
Fish glue is made from fish waste and is particularly environmentally friendly. It is well suited to wood joints and restoration work because it is reversible and can easily be released again.
D4 glue is a special wood glue that meets the requirements of DIN EN 204/205 D4. It is particularly water-resistant and suitable for use outdoors or in damp interiors.
Handling adhesives correctly
Glued parts form a material bond that can only be separated again by destroying the material. There are suitable adhesives for different materials. The better the surface adhesion and the internal strength (cohesion) of the adhesive, the more durable the bond. The adhesive should be applied evenly and not too thickly. Dust and grease on the surfaces to be glued reduce adhesion considerably.
Suitable for application are:
- Nozzle
- Brush
- Spreader
- Roller
- Spray can
The application tools should be cleaned immediately after use.
Applying wood glue correctly
Solid edging strips are attached to board edges with white glue. The glue is applied with the nozzle of the glue bottle and then spread with a brush. On dense boards, applying glue to one side is enough. On coarse-pored substrates the board edge should be coated with glue as well.
Several board edges can be glued at the same time if you clamp the boards together. When veneering, the glue is applied in a criss-cross pattern to the substrate only. For dovetail and finger joints the brush must be small enough to get the glue into the corners. For mortise-and-tenon and bridle joints, glue is applied with a wooden spatula to the cheeks and the bottom of the slot.
Special cases
- Parquet glue is applied sparingly, and excess glue is wiped off immediately.
- Biscuit slots require special glue bottles with holes in the sides.
- Narrow joints are filled with glue using a medical syringe.
- Two-component adhesive has to be mixed before application.
- Contact adhesive is applied over the whole surface on both sides and must flash off before the parts are joined.
- Tile adhesive and floor-covering adhesive are applied with notched trowels.
- Spray adhesive is easy to apply thinly and evenly.
Tip: Special glue pots are available in the shops that cover the glue-wet brush airtight and so save glue and time.
When buying adhesive, always check which materials are to be bonded. That saves trouble and, in the long run, money.

