I mix my lime paint myself. Lime putty (slaked lime that has been matured under water) works best. You can also buy it in bags in Romania (‘var pastă’ or ‘var bulgări’). It is, however, the most expensive option, because it is matured for at least several months and up to years. The longer the lime matures, the purer it becomes.
For lime putty matured for two and a half years I pay about €20 per 10 kg here in Germany (as of 2020). I have bought some in Romania too, but I no longer know the price because I bought a lot of other building materials at the same time.
I then mix the lime putty with water in a bucket. The ratio is almost one to one, slightly more water than lime, until it has a brushable consistency.
If it is to be coloured, I mix in pigments (use lime-fast pigments). But it must not be more than 5%, otherwise the paint will chalk later. So I cannot achieve really strong colours, but they would not suit the house anyway.
I leave the whole thing to stand for a day, stirring now and then so that the lime does not settle. Here again: the longer the paint stands, the better the quality.
White lime paint can also be applied with a roller; with coloured paint that does not look as nice, so I use a painter’s brush (with natural bristles in each case). Brush crosswise and apply the paint in 3–4 coats. Leave each coat to dry for 24 hours; only the last coat is applied in colour. That looks best afterwards.
Applying and drying
After drying, the paint chalks a little when you wipe over it. The more slowly it dries, the better. So do not paint in high summer if you can avoid it, because the paint ‘burns’. A temperature between 10 and at most 18 degrees Celsius is ideal.
The paint does not harden because the water escapes, but through carbonation. The lime takes CO2 from the air and bonds with it. It gradually turns to stone, so to speak.
Wipe-resistant lime paint: linseed oil and quark
You can also mix in a little linseed oil (2–3%), which helps, for example, if the substrate is very absorbent. It also makes the paint more wipe-resistant.
If the coat is to be wipe-resistant, stir a pack of low-fat quark (250 g) into about 100 g of lime putty until you have a homogeneous, honey-like mass. This is then added to the paint: 95% paint, 5% of the mass. Because of the quark, however, the paint should not be kept for too long.
Lime paint from bagged hydrated lime
I have also tried dry hydrated (air) lime in bags. I first soaked it for at least 24 hours before processing it further as described above. The result is not quite as good as with long-matured lime putty, but still far better than ready-made products.
Lime paint on fresh lime plaster
When I plaster a wall with lime mortar, I apply a coat of lime paint 24 hours after plastering. This gives a beautiful and extremely resistant (hard) surface.
Conclusion: the benefits of lime paint
Lime paint is a natural product with many advantages. To make use of them, you have to accept the properties of the material. In my experience, plenty of time and the right working temperature are the most important foundations for an attractive and long-lasting result.
